Machsupport Forum
Mach Discussion => Mach4 General Discussion => Topic started by: J.Hunter on July 27, 2017, 07:10:02 AM
-
Any word on when this will happen? Without tangential I can't use it on the systems I build.
-
Have you tried it? Tangential is a choice in the config dialog.
Steve
-
I do not see Tagential as a option is Mach 4. Is it there somewhere and I am missing it?
-
Look on the Config > Mach page under the General tab. There is a selection
area on the left side called "Control Mode" and you will find tangential in the
drop down selections.
Steve Stallings
www.PMDX.com