Chaoticone,
I purchased the license and had issues getting it to do anything.
There is no documentation.
No sample as shown in Screen Movie or Screen shot.
I have had no response from support.
After a few hours I found that you had to populate the Tool Table.
You have to figure out that you need to also put values in the Colors to make the Tool and Cut other than black.
On you website you have a display cut with multiple colors, how is this done?
http://www.machsupport.com/3d-cutting-simulator-moduleworks-plugin/Where does the Simulation Tab get the sizes and Tool location X/Y and Z height from?
Example:
Actual Cylinder size should be 51 Radius 10 High, but it starts off at 100 Radius and 50 High.
X/Y/Z is all ZERO Top and Center of Cylinder, but the Tool shows through the other side.
Have to make an approximate guess of the value of Z = -44.7, in the G-Code it starts off Z20 and then goes down to Z0 and after several cuts down to Z-3.25.
So how do you get the correct height of the Material guess?
Is there a way to configure a Tapered Ballnose or D-Bit cutters in the Tool Table, if not will this ever be introduced into this module?
Will this Module ever support 4 Axis simulation?
Will the final release have these features.
Other than these issue it does do a nice job.
Regards,
Mauri.