Hello Guest it is May 26, 2024, 04:39:40 AM

Author Topic: Double cuts  (Read 1552 times)

0 Members and 1 Guest are viewing this topic.

Double cuts
« on: March 17, 2017, 06:10:44 PM »
I wrote a gcode to do some.5 dia holes and some.25dia. When mach3 cuts 1 hole out it does it again for no reason. I checked my card and it say it does 6 passes per hole where mach3 is doing 12. Why do I have something set wrong. Another thing it is doing is not cutting the holes out to the proper dia they are about .013 undersized. I checked all my axis for Cal and set my back lash but it's still there.
Re: Double cuts
« Reply #1 on: March 18, 2017, 11:28:42 AM »
post your gcode and micrometer your bit