Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: kharrisonkevin on March 17, 2017, 06:10:44 PM

Title: Double cuts
Post by: kharrisonkevin on March 17, 2017, 06:10:44 PM

I wrote a gcode to do some.5 dia holes and some.25dia. When mach3 cuts 1 hole out it does it again for no reason. I checked my card and it say it does 6 passes per hole where mach3 is doing 12. Why do I have something set wrong. Another thing it is doing is not cutting the holes out to the proper dia they are about .013 undersized. I checked all my axis for Cal and set my back lash but it's still there.

Title: Re: Double cuts
Post by: rhtuttle on March 18, 2017, 11:28:42 AM

post your gcode and micrometer your bit