Hello Guest it is October 19, 2019, 04:30:16 PM

Author Topic: Mac3 software  (Read 1059 times)

0 Members and 1 Guest are viewing this topic.

Mac3 software
« on: March 08, 2017, 08:00:19 PM »
When I go to motor tuning and put velocity  data in.  When I tab to acceleration the velocity goes to zero.

Any suggestions?

Offline kolias

*
  •  1,011 1,011
    • View Profile
Re: Mac3 software
« Reply #1 on: March 08, 2017, 08:08:51 PM »
On which axis this happens? what are the other values on the screen?
Nicolas
Re: Mac3 software
« Reply #2 on: March 08, 2017, 08:21:50 PM »
All axes.   Currently working on x axes.
Re: Mac3 software
« Reply #3 on: March 08, 2017, 08:23:28 PM »
200 in steps acceleration 10

Offline Davek0974

*
  •  2,580 2,580
    • View Profile
    • DD Metal Products Ltd
Re: Mac3 software
« Reply #4 on: March 09, 2017, 06:08:24 AM »
Did you remember to press "Save Axis Settings" before changing the tab/screen??
Bridgeport Mill, Mach3 V062, CSMIO-IP/A controller, AC Servo Drives
Re: Mac3 software
« Reply #5 on: March 09, 2017, 07:47:51 AM »
Never get that far

Offline Tweakie.CNC

*
  • *
  •  7,950 7,950
  • Super Kitty
    • View Profile
    • Tweakie.CNC
Re: Mac3 software
« Reply #6 on: March 09, 2017, 08:11:32 AM »
Sounds like a bad install.

Try re-installing Mach3 (version R3.043.062 would be best) and see if that cures the problem.

Tweakie.
Success consists of going from failure to failure without loss of enthusiasm.  Winston Churchill.