Hello Guest it is November 22, 2019, 08:17:25 AM

Author Topic: Missing Touch button  (Read 747 times)

0 Members and 1 Guest are viewing this topic.

Missing Touch button
« on: February 23, 2017, 01:19:57 PM »
Had a computer die. New computer, installed Mach 4 2.0.3233. New license for new computer. Using previously good profile.
All is fine except TOUCH button is now missing from the screen. I only use this to set Z height with a Wildhorse probe set as a height probe.
How can I get the button back?
Thanks

Offline mark4

*
  •  147 147
    • View Profile
Re: Missing Touch button
« Reply #1 on: February 24, 2017, 08:42:30 PM »
hi how was the button added to begin with did it come with a screen set and did you restore from a backup. if you restored from a backup it should be there. can you get into the old hdd at all to get your backup. that should be a good place to start
mark
Re: Missing Touch button
« Reply #2 on: February 24, 2017, 10:26:40 PM »
Figured it out. It was on another screen set. I'll post the name tomorrow in case anyone else is missing it.
Thanks for the reply