Machsupport Forum

Mach Discussion => Mach4 General Discussion => Topic started by: sshire on February 23, 2017, 01:19:57 PM

Title: Missing Touch button
Post by: sshire on February 23, 2017, 01:19:57 PM

Had a computer die. New computer, installed Mach 4 2.0.3233. New license for new computer. Using previously good profile.
All is fine except TOUCH button is now missing from the screen. I only use this to set Z height with a Wildhorse probe set as a height probe.
How can I get the button back?
Thanks

Title: Re: Missing Touch button
Post by: mark4 on February 24, 2017, 08:42:30 PM

hi how was the button added to begin with did it come with a screen set and did you restore from a backup. if you restored from a backup it should be there. can you get into the old hdd at all to get your backup. that should be a good place to start
mark

Title: Re: Missing Touch button
Post by: sshire on February 24, 2017, 10:26:40 PM

Figured it out. It was on another screen set. I'll post the name tomorrow in case anyone else is missing it.
Thanks for the reply