Hello Guest it is May 14, 2021, 03:30:27 AM

Author Topic: selected tool slot number to large  (Read 918 times)

0 Members and 1 Guest are viewing this topic.

selected tool slot number to large
« on: February 18, 2017, 11:18:11 AM »
I am trying to set up my master tool 1 for my lathe in mach4. When i type t0101 in MDI and hit cycle start to activate tool offset 1 I get selected tool slot number to large. I am sure I have I have setup something wrong but have no clue any ideals. Thanks
Re: selected tool slot number to large
« Reply #1 on: February 19, 2017, 10:40:42 AM »
Fixed I had mill tool table in stead of lathe tool off sets