Machsupport Forum

Mach Discussion => Mach4 General Discussion => Topic started by: wwenter on February 18, 2017, 11:18:11 AM

Title: selected tool slot number to large
Post by: wwenter on February 18, 2017, 11:18:11 AM

I am trying to set up my master tool 1 for my lathe in mach4. When i type t0101 in MDI and hit cycle start to activate tool offset 1 I get selected tool slot number to large. I am sure I have I have setup something wrong but have no clue any ideals. Thanks

Title: Re: selected tool slot number to large
Post by: wwenter on February 19, 2017, 10:40:42 AM

Fixed I had mill tool table in stead of lathe tool off sets