Hello Guest it is March 28, 2024, 09:06:30 PM

Author Topic: Help Motion Steps Overflow  (Read 1441 times)

0 Members and 1 Guest are viewing this topic.

Help Motion Steps Overflow
« on: February 13, 2017, 09:44:29 PM »
I'm getting an error when I jog sometimes. I'm not moving fast at all, like maybe 5-15 IPM. When I'm done jogging I get "Motion Steps Overflow 2532 Check Motor Speed Parameters"

Anyone have any suggestions? I need this to be stable before I actually run anything on my lathe.
Re: Help Motion Steps Overflow
« Reply #1 on: February 13, 2017, 10:31:05 PM »
I would think that relates to an acceleration or deceleration rate rate set too high.
Re: Help Motion Steps Overflow
« Reply #2 on: February 13, 2017, 10:46:40 PM »
Ah ok. I'll try toneing it down.