Machsupport Forum
Mach Discussion => Mach4 General Discussion => Topic started by: Cartierusm on February 13, 2017, 09:44:29 PM
-
I'm getting an error when I jog sometimes. I'm not moving fast at all, like maybe 5-15 IPM. When I'm done jogging I get "Motion Steps Overflow 2532 Check Motor Speed Parameters"
Anyone have any suggestions? I need this to be stable before I actually run anything on my lathe.
-
I would think that relates to an acceleration or deceleration rate rate set too high.
-
Ah ok. I'll try toneing it down.