Hello Guest it is December 06, 2019, 12:42:34 PM

Author Topic: USB Control  (Read 3537 times)

0 Members and 1 Guest are viewing this topic.

USB Control
« on: March 17, 2006, 02:30:55 PM »
I notice that on the engine configuration ports screen there is a section labeled "USB Mode".  Can anyone tell me what hardware is required to use this mode?

Sam
Re: USB Control
« Reply #1 on: March 17, 2006, 07:36:12 PM »
Sam where is that??
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com
Re: USB Control
« Reply #2 on: March 18, 2006, 04:30:49 PM »
I saw it in the 'Mach2.6.11.pdf' file.  It is a screenshot of the engine configuration, ports and pins page.
Thanks, Sam
Re: USB Control
« Reply #3 on: March 19, 2006, 08:37:09 AM »
I see :) That is from the very old Mach G2000 project that is now the Grex. The Grex runs over a network connection now...
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com