Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: sdspurlock on March 17, 2006, 02:30:55 PM
-
I notice that on the engine configuration ports screen there is a section labeled "USB Mode". Can anyone tell me what hardware is required to use this mode?
Sam
-
Sam where is that??
-
I saw it in the 'Mach2.6.11.pdf' file. It is a screenshot of the engine configuration, ports and pins page.
Thanks, Sam
-
I see :) That is from the very old Mach G2000 project that is now the Grex. The Grex runs over a network connection now...