Hello Guest it is August 07, 2020, 05:29:01 PM

Author Topic: Change Wiring  (Read 1318 times)

0 Members and 1 Guest are viewing this topic.

Offline kolias

*
  •  1,011 1,011
    • View Profile
Change Wiring
« on: February 04, 2017, 01:58:44 PM »
My setup with the G540 is all complete and works fine but the motors direction is not the way I wanted. Like when I press the page UP keyboard button the Z axis goes down. I know I can change the Active Low from green to red or from red to green or perhaps from the Homing / Limits page click on the Reverse column? 

It’s also easy for me to switch the motor wiring but I don’t know which pair. From the attached Keling wiring schematic which pair of wires will change the motor direction?

Nicolas
Re: Change Wiring
« Reply #1 on: February 04, 2017, 05:15:26 PM »
Hi,
just change one pair, keep the blue and red together and the green and yellow together, but swap the terminals
in which they go.

Craig
My wife left with my best friend...
     and I miss him!

Offline kolias

*
  •  1,011 1,011
    • View Profile
Re: Change Wiring
« Reply #2 on: February 04, 2017, 06:16:19 PM »
Thanks Craig, will give it a try
Nicolas

Offline ger21

*
  • *
  •  6,282 6,282
    • View Profile
    • The CNC Woodworker
Re: Change Wiring
« Reply #3 on: February 04, 2017, 09:36:19 PM »
Checking the Reverse column is a lot easier than changing wires.
Gerry

2010 Screenset
http://www.thecncwoodworker.com/2010.html

JointCAM Dovetail and Box Joint software
http://www.g-forcecnc.com/jointcam.html

Offline kolias

*
  •  1,011 1,011
    • View Profile
Re: Change Wiring
« Reply #4 on: February 04, 2017, 10:10:40 PM »
You are right Gerry, wiring was not as easy as i thoought and the Reverse column did the trick, thanks
Nicolas