Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: kolias on February 04, 2017, 01:58:44 PM
-
My setup with the G540 is all complete and works fine but the motors direction is not the way I wanted. Like when I press the page UP keyboard button the Z axis goes down. I know I can change the Active Low from green to red or from red to green or perhaps from the Homing / Limits page click on the Reverse column?
It’s also easy for me to switch the motor wiring but I don’t know which pair. From the attached Keling wiring schematic which pair of wires will change the motor direction?
-
Hi,
just change one pair, keep the blue and red together and the green and yellow together, but swap the terminals
in which they go.
Craig
-
Thanks Craig, will give it a try
-
Checking the Reverse column is a lot easier than changing wires.
-
You are right Gerry, wiring was not as easy as i thoought and the Reverse column did the trick, thanks