Hello Guest it is October 19, 2019, 06:46:54 PM

Author Topic: Larning th hard way.  (Read 1513 times)

0 Members and 1 Guest are viewing this topic.

Offline Tweakie.CNC

*
  • *
  •  7,950 7,950
  • Super Kitty
    • View Profile
    • Tweakie.CNC
Larning th hard way.
« on: December 31, 2016, 03:03:02 AM »
Just as a tip to othrs, whn th workshop nds claning tak car whn using th shop vac on th computr kyboard. It mad such a good job on min that I had to spnd about an hour going through th bag dust and shavings to find my missing kytops – and thr is still on missing.  :'(

Twaki.
Success consists of going from failure to failure without loss of enthusiasm.  Winston Churchill.

Offline RICH

*
  • *
  •  7,367 7,367
    • View Profile
Re: Larning th hard way.
« Reply #1 on: December 31, 2016, 06:08:16 AM »
I quess you lost the "E" keytop.  ;D

Sucks doesn't it!  :D

RICH

Offline Tweakie.CNC

*
  • *
  •  7,950 7,950
  • Super Kitty
    • View Profile
    • Tweakie.CNC
Re: Larning th hard way.
« Reply #2 on: December 31, 2016, 07:40:38 AM »
Found it  ;D

Tweakie.
Success consists of going from failure to failure without loss of enthusiasm.  Winston Churchill.
Re: Larning th hard way.
« Reply #3 on: December 31, 2016, 03:14:12 PM »
My shop vac has a cyclonic separator between the vac and the hose. Most of the tools and parts I suck up are sitting on top of the pile in the separator instead of in the bag with the fine particles!