Machsupport Forum

Tangent Corner => Tangent Corner => Topic started by: Tweakie.CNC on December 31, 2016, 03:03:02 AM

Title: Larning th hard way.
Post by: Tweakie.CNC on December 31, 2016, 03:03:02 AM
Just as a tip to othrs, whn th workshop nds claning tak car whn using th shop vac on th computr kyboard. It mad such a good job on min that I had to spnd about an hour going through th bag dust and shavings to find my missing kytops – and thr is still on missing.  :'(

Twaki.
Title: Re: Larning th hard way.
Post by: RICH on December 31, 2016, 06:08:16 AM
I quess you lost the "E" keytop.  ;D

Sucks doesn't it!  :D

RICH

Title: Re: Larning th hard way.
Post by: Tweakie.CNC on December 31, 2016, 07:40:38 AM
Found it  ;D

Tweakie.
Title: Re: Larning th hard way.
Post by: garyhlucas on December 31, 2016, 03:14:12 PM
My shop vac has a cyclonic separator between the vac and the hose. Most of the tools and parts I suck up are sitting on top of the pile in the separator instead of in the bag with the fine particles!