Author Topic: PROBLEMA WITH G CODE AND MACH3  (Read 1163 times)

0 Members and 1 Guest are viewing this topic.

Offline llamame_noel

  • Holding
  • Posts: 2
    • View Profile
PROBLEMA WITH G CODE AND MACH3
« on: December 13, 2016, 06:03:39 PM »
I need help!!!!!


When I open a cogigo g on mach3, I can not see the complete model (only a small part of it). What am I doing wrong.


Online Tweakie.CNC

  • Global Moderator
  • *
  • Posts: 7,684
  • Super Kitty
    • View Profile
    • Tweakie.CNC
Re: PROBLEMA WITH G CODE AND MACH3
« Reply #1 on: December 14, 2016, 02:19:35 AM »
If you are using Mach3 in Demo Mode (Unlicensed) then it will only display the first 500 lines of Gcode.
Purchasing a license resolves this issue http://www.machsupport.com/shop/mach3/

Tweakie.
Success consists of going from failure to failure without loss of enthusiasm.  Winston Churchill.