Hello Guest it is March 28, 2024, 10:44:42 AM

Author Topic: Minor problem  (Read 2281 times)

0 Members and 1 Guest are viewing this topic.

Minor problem
« on: June 03, 2007, 08:38:10 PM »
Hi guys; I'm trying to make two pockets (Slots really) in a piece of .375 material. The "outer" slot is .250 deep and then the "inner"  slot goes through the material. To save some moves I tried setting the "Start Cut" of the inner slot to -.250 after the outer has been routed. As you can see in the attached screenshot LC acts like it Start Cut parameter is always a positive value. Setting Start Cut to 0 produces the expected result.

Have a good one.
Re: Minor problem
« Reply #1 on: June 05, 2007, 09:58:12 AM »
How did I let that one past... O will see if I can find the problem here.

Thanks
Brian
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com