I'm sorry but I'm sure where the setting page is. If it's on the ports and pins page. yes it it is set,
Maybe I'm not real clear on what i'm looking for.
I'm running a Plasma torch with X, Y, Z and A ( A is running with X on the Gantry). The download from geckodrive that I installed is for a mill operation and that will run X, Y, Z. and I guess I need to know what do i have to do to get the Mach3 Plasma to send a signal to the geckodrive. I checked the ports and pins and they are set correctly (as far I know) and i'm not sure what will trigger it to send a signal to the drive. I've look on youtube and couldn't find anything that would help. everything was for a mill set up.
I hope I'm a little clearer
Thank you very much for helping I'm artist not really good at setting up computers
Thanks
Kevin