Hello Guest it is March 29, 2024, 11:21:50 AM

Author Topic: Migrate from Mach3 - 4 (XYYZ) CNC  (Read 1922 times)

0 Members and 1 Guest are viewing this topic.

Migrate from Mach3 - 4 (XYYZ) CNC
« on: October 02, 2016, 02:40:27 AM »
Hi Everyone

I think it is time to give Mach4 a try again. I did when it came out but had no success.

Are there anyone that have done this successfully to gibe me pointers, or even better is there a way to migrate my Madh3 config to Mach4?

I remember I had a problm to hpget tje Dawin parallel port emulator to,work.....

Rgs
Scalci
Re: Migrate from Mach3 - 4 (XYYZ) CNC
« Reply #1 on: October 02, 2016, 08:44:00 AM »
I am currently upgrading a Mach 3 machine to Mach 4 and all is going well.  I built a new PC and I am using a PMDX-424 motion controller to replace the old breakout board/ parallel port setup.  I just took screenshots of the mach 3 pin and motor settings and entered those into Mach 4.