Machsupport Forum
Mach Discussion => Mach4 General Discussion => Topic started by: scalci on October 02, 2016, 02:40:27 AM
-
Hi Everyone
I think it is time to give Mach4 a try again. I did when it came out but had no success.
Are there anyone that have done this successfully to gibe me pointers, or even better is there a way to migrate my Madh3 config to Mach4?
I remember I had a problm to hpget tje Dawin parallel port emulator to,work.....
Rgs
Scalci
-
I am currently upgrading a Mach 3 machine to Mach 4 and all is going well. I built a new PC and I am using a PMDX-424 motion controller to replace the old breakout board/ parallel port setup. I just took screenshots of the mach 3 pin and motor settings and entered those into Mach 4.