Hiya,
yes i usually go bottom left but that won't work when you have to work both sides of a part and the features need to align - the bottom left becomes top left when part is flipped over
(flipped along the X axis)
I'm just trying to get a good hold on what is going to happen when i finally get to make the parts i need, been drawing and cam'ing it in Fusion360, then reading the code, figuring out just what its doing, luckily F360 writes nice code
But when i load into my Mach simulator (laptop, no motion) the part is below the cross-hairs which is correct, i can drag it up but do a regen and it disappears again