I figured out I had to do a fresh install of the latest version to get the Hicon to communicate properly. I now have a dozen or so rungs working in the PMC. I am stuck on one right now that I just can't figure out. I have LED's that represent different jog increments (.01, .001, .0001). I have Mach4 setup to only step through these increments. I want each LED to light up when the corresponding step increment is active. I tried reading the jogincx variable into PMC using a read from register instruction, but it seems it is not reading the decimal value (I assume because the variable is long dim). How do I read this data type?
Thanks!
and BTW, I am way ahead of where I would be without the PMC.