Hi,
I have Smoothstepper setup and have run it With pmdx 126 for a while now.
I am configuring my CNC for use with an Engraving Laser Diode.
To control my Laser Driver i have three signals: Driver On, Beam On and Beam Intensity (PWM).
I want to control Beam on using M62 P0 (Followed by a Move Command G1 X...)
I have tried different connections on the pmdx Port#1Pin#1, Port#2Pin16 and 17 but non seems to work.
Further investigation using the diagnostic screen shows that Output 0 Never toggles to On..... No matter of hardware configuration this should toggle right? Im running build 2914 of Mach 4.
Can anyone point me in the right direction?