Hello Guest it is March 29, 2024, 10:34:13 AM

Author Topic: Who can help ? my X-axis only wants to move in 1 direction  (Read 3032 times)

0 Members and 1 Guest are viewing this topic.

Hi there,

I just changed from a parallel situation to USB, Parallel is just too old and not stable enough for me.

I bought an XhC Mach3 USB control card (4 axis). I wired everything, checked and double checked. Y/Z works fine. The X-axis only wants to move in 1 direction when toggled. I tried about every function n Mach3, i just cannot invert the direction, and am not able to make it goi in both directions. I checked the wire from driver to the controlcard and "beeped"it. The cable is ok. All drivers have exactly the same dipswitches activ, same drivers, same steppermotors.

The last few hair i have go grey, can some-one help me ?

Thanx in advance

Fred
Re: Who can help ? my X-axis only wants to move in 1 direction
« Reply #1 on: May 09, 2016, 05:06:44 PM »
swap motors to identify is motor and wiring ok, swap just driver to ensure driver ok, double check config.
Re: Who can help ? my X-axis only wants to move in 1 direction
« Reply #2 on: May 10, 2016, 04:15:21 AM »
i swapped the wiring between USB card and Driver from X axis to Z axis. Now the Z axis only moves to one side only, and X moves normal.

Does this mean the USB control card has a malfunction?
Re: Who can help ? my X-axis only wants to move in 1 direction
« Reply #3 on: May 14, 2016, 05:29:43 AM »
I found the error. It was the direction wire that did not make good contact.