Hello Guest it is March 28, 2024, 09:34:39 AM

Author Topic: Mach3 et SMC800  (Read 3559 times)

0 Members and 1 Guest are viewing this topic.

Mach3 et SMC800
« on: May 19, 2007, 05:00:21 PM »
Bonsoir, je n'arrive pas à configurer mach3 pour une commande d'axe smc800

merci de m'aider
Re: Mach3 et SMC800
« Reply #1 on: May 20, 2007, 08:46:37 AM »
Hi Philippe

I do not understand the language but if you mean the SMC800 board from CONRAD, i dont think it will work with Mach3 because it has its own interpreter of step and direction signals and therefore it needs special software.
I myself has the SMC1500 with an extention board on it to make it listen to normal step and direction signals.

Greetings:
Willem