Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: philippe33 on May 19, 2007, 05:00:21 PM
-
Bonsoir, je n'arrive pas à configurer mach3 pour une commande d'axe smc800
merci de m'aider
-
Hi Philippe
I do not understand the language but if you mean the SMC800 board from CONRAD, i dont think it will work with Mach3 because it has its own interpreter of step and direction signals and therefore it needs special software.
I myself has the SMC1500 with an extention board on it to make it listen to normal step and direction signals.
Greetings:
Willem