Hello Guest it is October 17, 2019, 02:27:57 AM

Author Topic: Mach4 + Hicon7766 + SheetCam post processor file  (Read 2923 times)

0 Members and 1 Guest are viewing this topic.

Mach4 + Hicon7766 + SheetCam post processor file
« on: April 15, 2016, 06:43:15 PM »
Hi all,

Need some support over here. I´m new on this and any help is appreciated.

Building from scratch a plasma CNC using the Hicon 7766 and mach4 SW. Has been a challenge but, so far so good with the great support of Marc from Vitalsystems.

I´ve now a new issue:
Installed SheetCAM and was asked for the post processor file. I´ve searched without success. Does this file exist? if so can anyone help me?

Thx, Joao
« Last Edit: April 15, 2016, 06:49:46 PM by JoaoSilva »
Re: Mach4 + Hicon7766 + SheetCam post processor file
« Reply #1 on: April 18, 2016, 11:45:17 AM »
Received this info from the SheetCAM team.

The 'Mach3' post should work. If you are plasma cutting use the 'Mach3 plasma' post
Re: Mach4 + Hicon7766 + SheetCam post processor file
« Reply #2 on: November 25, 2016, 11:27:29 PM »
I think I can help you out with this. I had sheetcam do a custom post for this
Re: Mach4 + Hicon7766 + SheetCam post processor file
« Reply #3 on: November 25, 2016, 11:28:11 PM »
EMAIL me at austinbrackin32@gmail.com