Machsupport Forum
Third party software and hardware support forums. => HiCON Motion Controller => Topic started by: JoaoSilva on April 15, 2016, 06:43:15 PM
-
Hi all,
Need some support over here. I´m new on this and any help is appreciated.
Building from scratch a plasma CNC using the Hicon 7766 and mach4 SW. Has been a challenge but, so far so good with the great support of Marc from Vitalsystems.
I´ve now a new issue:
Installed SheetCAM and was asked for the post processor file. I´ve searched without success. Does this file exist? if so can anyone help me?
Thx, Joao
-
Received this info from the SheetCAM team.
The 'Mach3' post should work. If you are plasma cutting use the 'Mach3 plasma' post
-
I think I can help you out with this. I had sheetcam do a custom post for this
-
EMAIL me at austinbrackin32@gmail.com