Hello Guest it is November 13, 2019, 10:22:57 PM

Author Topic: whats going on with this gcode and file?  (Read 1101 times)

0 Members and 1 Guest are viewing this topic.

whats going on with this gcode and file?
« on: March 16, 2016, 12:14:19 PM »
I've been given a file exported from Sketchup and formatted in various ways to cut out using the plasma. I've taken the file into sheetcam, run the post processor and imported to Mach3.

What are these concentric rings showing? I dont usually have these!

See the original file, sheetcam gcode and screengrab for details. Any thoughts welcome..

 

Offline Tweakie.CNC

*
  • *
  •  7,986 7,986
  • Super Kitty
    • View Profile
    • Tweakie.CNC
Re: whats going on with this gcode and file?
« Reply #1 on: March 16, 2016, 12:18:26 PM »
Config / General Config.  change the IJ Mode (then regen. toolpath)

Ideally your Gcode should include the G90.1 or G91.1 as appropriate.

Tweakie.
Success consists of going from failure to failure without loss of enthusiasm.  Winston Churchill.
Re: whats going on with this gcode and file?
« Reply #2 on: March 16, 2016, 12:26:42 PM »
Thanks :)