Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: marbles on March 16, 2016, 12:14:19 PM

Title: whats going on with this gcode and file?
Post by: marbles on March 16, 2016, 12:14:19 PM
I've been given a file exported from Sketchup and formatted in various ways to cut out using the plasma. I've taken the file into sheetcam, run the post processor and imported to Mach3.

What are these concentric rings showing? I dont usually have these!

See the original file, sheetcam gcode and screengrab for details. Any thoughts welcome..

 
Title: Re: whats going on with this gcode and file?
Post by: Tweakie.CNC on March 16, 2016, 12:18:26 PM
Config / General Config.  change the IJ Mode (then regen. toolpath)

Ideally your Gcode should include the G90.1 or G91.1 as appropriate.

Tweakie.
Title: Re: whats going on with this gcode and file?
Post by: marbles on March 16, 2016, 12:26:42 PM
Thanks :)