I wanted to do one pass on the drum sander but had to do as many as 5 on some pcs. I couldn't put multiple pcs through the drum sander because it would bog the motor down too much. So I had to break each one out individually. That resulted in hours of manual work and a lot of scratches and bleeding on my arms from breaking the pcs apart. I definitely got an education. I would just really like to develop a sweet hold down system for cutting these parts out without much work after the fact. We are a production shop, and my job is primarily finding out ways to minimize or eliminate manual labor from the process. In my line of work, volume is the name of the game. We are stealing work away from the Chinese exporters; but in order to do this, you have to be able to automate and eliminate steps to the final product. I'd like to be able to cut these out and send them directly to paint, but at this point, I can't figure out a way to get it done.