Hello Guest it is May 07, 2021, 01:11:56 AM

Author Topic: Mill to lathe configuration  (Read 1078 times)

0 Members and 1 Guest are viewing this topic.

Mill to lathe configuration
« on: February 10, 2016, 06:42:21 PM »

I have a Shopmaster Eldorado that is a Lathe, Mill combo.  I use it mostly for hobby work and also to help repair car wash problems

I want to run the lathe and I know I read some where  how to configure the  settings to run X/Y instead of X,Y and Z on the mill side but I haven't found it.  I have never tried any serious lathe work but want to play.

I want to configure the lathe to run CNC and learn a bit about threading.  Any help would be good
Re: Mill to lathe configuration
« Reply #1 on: February 11, 2016, 04:08:49 PM »
I found the answer  thank you