Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: johnny on February 10, 2016, 06:42:21 PM
-
I have a Shopmaster Eldorado that is a Lathe, Mill combo. I use it mostly for hobby work and also to help repair car wash problems
I want to run the lathe and I know I read some where how to configure the settings to run X/Y instead of X,Y and Z on the mill side but I haven't found it. I have never tried any serious lathe work but want to play.
I want to configure the lathe to run CNC and learn a bit about threading. Any help would be good
-
I found the answer thank you