Hello Guest it is May 30, 2023, 01:43:27 AM

Author Topic: C10 bob and a chinese spindle.  (Read 1082 times)

0 Members and 1 Guest are viewing this topic.

C10 bob and a chinese spindle.
« on: January 24, 2016, 07:26:28 AM »
I have spent the last two hours looking for someone with what must be a pretty common scenario.....

I have a C10 break out board and am trying to wire up my Chinese ebay 2.2kw spindle and controller.

In the default manual control via the spindle controller key pad, everything works.

My problem seems to be around the wiring/mach 3 config.

Let me start with one simple question to validate/invalidate my basic premise:   Is it valid to wire and configure an output pin (14 in my case) direct to the VI pin on the speed controller and expect it to control the spindle speed?  Lets assume I have the PIDs all set right....for now.

Thanks in advance.