Hello Guest it is April 20, 2024, 06:51:35 AM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: slave axis not working  (Read 2299 times)

0 Members and 1 Guest are viewing this topic.

Offline duffman

*
  • 1 1
    • View Profile
slave axis not working
« on: January 18, 2016, 02:50:09 PM »
hi folks newbie to this forum

im trying to slave my y-a but with no joy. i have tried everything that i have come across on fourms but nothing.
is there anyone who could shed some light on it for me ????

thanks
Logged

Offline Chipteck

*
  • 3 3
    • View Profile
Re: slave axis not working
« Reply #1 on: September 01, 2016, 04:46:49 PM »
Have you resolved your problem?
Logged

Offline Ford Prefect

*
  • 65 65
    • View Profile
Re: slave axis not working
« Reply #2 on: September 02, 2016, 07:44:32 AM »
I used the config/slave axis
pull down window

You can also see how to do it in this PDF

http://www.machsupport.com/wp-content/uploads/2013/02/Mach3Mill_Install_Config.pdf

Figure 5-25: Configure Slave Axis Dialog

regards
Logged

Offline Chipteck

*
  • 3 3
    • View Profile
Re: slave axis not working
« Reply #3 on: September 02, 2016, 08:27:43 AM »
I was going to offer the same document..
Logged
Pages: 1   Go Up
« previous next »