Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: duffman on January 18, 2016, 02:50:09 PM
-
hi folks newbie to this forum
im trying to slave my y-a but with no joy. i have tried everything that i have come across on fourms but nothing.
is there anyone who could shed some light on it for me ????
thanks
-
Have you resolved your problem?
-
I used the config/slave axis
pull down window
You can also see how to do it in this PDF
http://www.machsupport.com/wp-content/uploads/2013/02/Mach3Mill_Install_Config.pdf
Figure 5-25: Configure Slave Axis Dialog
regards
-
I was going to offer the same document..