Author Topic: mach 3  (Read 1298 times)

0 Members and 1 Guest are viewing this topic.

Offline shoer2012

  • Active Member
  • Posts: 19
    • View Profile
mach 3
« on: January 13, 2016, 01:14:36 PM »
Hi I am new to CNC. I have a CNC plasma and I can not turn on my hypertherm 45 on and off.Do I need something else then the two wires from my ht45? Please help. Thanks.

Offline Ron Ginger

  • Active Member
  • Posts: 921
    • View Profile
Re: mach 3
« Reply #1 on: January 13, 2016, 03:29:10 PM »
I think you are looking in the wrong place for that help- this section is about the wizards which can be used to generate Gcode. Try your question in the main section of this forum.


Offline shoer2012

  • Active Member
  • Posts: 19
    • View Profile
Re: mach 3
« Reply #2 on: January 13, 2016, 06:24:20 PM »
Thanks Ron. I told you I was new.