Machsupport Forum
Third party software and hardware support forums. => Newfangled Mill Wizard => Topic started by: shoer2012 on January 13, 2016, 01:14:36 PM
-
Hi I am new to CNC. I have a CNC plasma and I can not turn on my hypertherm 45 on and off.Do I need something else then the two wires from my ht45? Please help. Thanks.
-
I think you are looking in the wrong place for that help- this section is about the wizards which can be used to generate Gcode. Try your question in the main section of this forum.
-
Thanks Ron. I told you I was new.