Thanks, I looked at the toolchanger video and it was helpful. However, I could not find the M6START.MLS they referenced as a starting point. Can you tell me where it is or if there are any tutorials on how to call/ format a macro? (I'm sure this is all obvious, just need a starting point)
Questions:
> how do you call a routine like an M command, for example "M6 T0101"?
> where are the macros or command scripts located? How do I access them to modify or add commands? Are there individual files for each command?
> is there a listing of the variable references? In reading some of the posted scripts I see the DROs for example are accessed by a variable number.
> is there a programming document that has all this in one place?
Tom