Hello Guest it is October 25, 2021, 12:26:07 AM

Author Topic: Taper correction  (Read 1471 times)

0 Members and 1 Guest are viewing this topic.

Taper correction
« on: December 15, 2015, 09:55:17 AM »
Hello!
The lathe I have cuts a bit tapered when moving in the Z axis only. It's less then 1 degree and it's annoying...
Is there a way Mach 3 can compensate this error in some way?
Thanks!


Inviato dal mio iPhone utilizzando Tapatalk
Taper correction
« Reply #1 on: December 18, 2015, 12:57:52 PM »
Hello??? :)


Inviato dal mio iPhone utilizzando Tapatalk