Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: resonance on December 15, 2015, 09:55:17 AM

Title: Taper correction
Post by: resonance on December 15, 2015, 09:55:17 AM

Hello!
The lathe I have cuts a bit tapered when moving in the Z axis only. It's less then 1 degree and it's annoying...
Is there a way Mach 3 can compensate this error in some way?
Thanks!


Inviato dal mio iPhone utilizzando Tapatalk

Title: Taper correction
Post by: resonance on December 18, 2015, 12:57:52 PM

Hello??? :)


Inviato dal mio iPhone utilizzando Tapatalk