Ive been running tests all day and im at a loss to figure out whats wrong.
I just installed v2.0 and am having trouble figuring this out
Here are the symptoms.
1. The z axis when traveling down 1" only goes down .995 . When I cycle it up and down, it always comes back to perfect 0 but never goes down below .995 .
This exact .005 error is happening with each Axis. It always arrives .005 short of the mark, but always returns to zero.
2. No matter how much adjusting I do with backlash compensation all my circles are all slightly round boxes. When I de energize the servos and roll them back and fourth by hand, there is zero play.
3. When I run a 350 line gcode file, that has a final depth cut of .225, the actual depth is .350 .
If anyone has any ideas, please let me know.
Rob