Hello Guest it is October 17, 2019, 01:58:55 AM

Author Topic: Bosch Colt with VS  (Read 977 times)

0 Members and 1 Guest are viewing this topic.

Offline kolias

*
  •  1,011 1,011
    • View Profile
Bosch Colt with VS
« on: November 03, 2015, 10:59:34 PM »
I used before a Colt and I was very happy with it. For my new small fixed gantry CNC I may use one again but perhaps there are other routers similar to Colt or even better.

Kress FME looks like a good router but I don’t know why is so expensive

Any other one? Must be small like the Colt and with VS (to be used for engraving / light aluminum cuts)
Nicolas
Re: Bosch Colt with VS
« Reply #1 on: November 04, 2015, 02:14:31 AM »
MAKITA RT0700C
http://www.icmsmakita.eu/cms/custom/uk/user_manual/RT0700C_20032012.pdf
https://www.youtube.com/watch?v=oe6S0VtoTgU

.... but it only comes with a 1/4" collet ......

you can however buy a selection of other collets (or just an 1/8" collet as I did) from Elaire Corporation http://www.elairecorp.com/makitaroutercollets.html

There is also this option too:
https://www.youtube.com/watch?v=8rp_nozyQo4
(few other posts on youtube... just search Makita CNC )

Rob
Rob

Albert Einstein ― “If you can't explain it to a six year old, you don't understand it yourself.”

Offline kolias

*
  •  1,011 1,011
    • View Profile
Re: Bosch Colt with VS
« Reply #2 on: November 04, 2015, 07:31:20 AM »
Thanks Rob, that's a pretty good one and I will have a look at it
Nicolas