Hello Guest it is December 07, 2024, 10:06:45 AM
Profile Guest

Poll

how to interface Mach 3 or 4 with LabView or C#? I.e., how to read out x,y,z from Mach 3 via C# or LabView ?  How to have a feedback from LabView or C# to Mach 3 to change its Feed Rate for eg.?

LabView
0 (0%)
C#
0 (0%)

Total Members Voted: 0

« previous next »
Pages: 1   Go Down

Author Topic: Mach3 or 4 interface with LabView or C#  (Read 2540 times)

0 Members and 1 Guest are viewing this topic.

Offline istvan

*
  • 1 1
Mach3 or 4 interface with LabView or C#
« on: October 19, 2015, 08:10:40 AM »
    Hello,

I am trying to interface Mach 3 (or 4) with either LabView or C#.

Reason:
a) I would like to read out x,y,z from Mach 3 via (into) C# or LabView. How can one do this?  
b) How to have a feedback from LabView or C# to Mach 3 to change its Feed Rate for example?

The reason for this is the fact that I have sensor info flowing in to C#/LabView that I would like to act upon, changing motor speeds. I also want to monitor movements outside Mach 3.

I have seen to possibility of having VS2008, macro pumps, brain or modbus --- but all these involve either in-Mach 3 processing or communicating to external PLCs. I only need a software interface to some external application/environment...  What is the best way to go?

Thanks a lot for your input! :)
Logged
Pages: 1   Go Up
« previous next »