Hello Guest it is March 28, 2024, 06:22:20 AM

Author Topic: NF Circle cut wizard  (Read 4304 times)

0 Members and 1 Guest are viewing this topic.

vmax549

*
NF Circle cut wizard
« on: May 05, 2007, 07:55:17 PM »
Good Evening Ron, I was using the cut circle wizard today and noticed a quirk. As the bit is leading into the circle just before it starts to cut the radius it does a little jog out of the circle leaving a small dimple cut about .020 deep. It does it on every pass at the same spot. Could you check it out? Thanks Terry Parker
Re: NF Circle cut wizard
« Reply #1 on: May 07, 2007, 06:05:11 PM »
Can you tell me more- what dia cicrle, what tool dia, did you select inside or outside circle?

I suspect this is a function of the tool radius comp, related to your tool size and circle dia.

vmax549

*
Re: NF Circle cut wizard
« Reply #2 on: May 07, 2007, 10:02:11 PM »
Hi ROn,

2.750" dia Circle
3/8 bit 3 flute carbide
inside cut
cw rotation
conventional cut


I use it again today with a different setup and it worked fine?????  (;-) TP