Hello Guest it is July 21, 2019, 09:37:44 AM

Author Topic: New to MACH - not 'new' to cnc - HELP! - need info  (Read 2960 times)

0 Members and 1 Guest are viewing this topic.

New to MACH - not 'new' to cnc - HELP! - need info
« on: May 05, 2007, 05:59:00 PM »
Hi! I'm Daveman. I've been in the sign business for 15 years, and have been using cnc (big Precix unit) for the last seven years. I design in Enroute. Last year I bought a Debece DTR 250-S cnc machine. Pretty well built - especially for the $$. But the base DOS communication software is very primative. There is little support here in the states (it would help if I spoke German, but hey?) Is anyone out there using MACH to control a Debece cnc machine? I apologise in advance for being a bit dumb about these topics, but I really haven't had time (or opportunity) to ask this question until I found the MACH website. Should I buy the software and get with it? Who has gone this route with Debece? Thanks sooo' much for 'any' direction and help that you can give me. I'm pretty familiar with the things that I do with cnc (see www.allsignsletters.com) but I'm a babe in the woods with things like this. Many Thanks in Advance, Daveman

Offline Graham Waterworth

*
  • *
  •  1,863 1,863
  • Yorkshire Dales, England
    • View Profile
Re: New to MACH - not 'new' to cnc - HELP! - need info
« Reply #1 on: May 06, 2007, 04:45:07 AM »
Looking at there web site I see no reason why Mach3 won't run the machine, all you would need to know is the pin out on the printer cable connection.

The current software should tell you all of this.

Graham.
Never give up, time will pass, the cloud will clear, the sun will shine once more.
Re: New to MACH - not 'new' to cnc - HELP! - need info
« Reply #2 on: May 22, 2007, 10:30:35 AM »
Thanks for the info regarding the Debece CNC and Mach suitability. Any further suggestions or info always appreciated. Daveman