I have a pre packaged table it was working ok I upgraded to the new nach 3 2 65 and it won't regen. toolpath past line 19 it says error plasma. o.o56 inch kerf 1/4
radius to end of arc differs from radius to start on line #19
and even before I have trouble scroling through the code if it screwed up to restart in the middle of a program still would'nt go past line 19.
I'm running a dyna cnc table with cand cnc thc mp 1000 sheetcam and mach.

Hi, Bogger44

Post your G-code file, Click on reply button there options to post your files there.

Under Config, General Config "Distance Mode and IJ Mode" the ABS and INC may be set wrong , change the IJ to opposite value.

In your G-code check near the top of your code for a G90, If there is a G91.1 or g90.1 on the same line, Edit and put it on it's own line.

G90, G91, G90.1, G91.1, Can't be on the same line.

Hope this Helps, Chip

g code is for touch n go floating plasma head