works fine here, .lic or not.
Only difference is ver and the port driver is loaded here.
Maybe load the driver ? ? and try it ? ?
Stranger things have happened.

There's a setting in General Config to ignore M codes when loading g-code. That may be your issue.

Thanks ger, found that; should I tick it's box then??

Gerry is faster typing than me. Yep tick the box ignore mcodes on load.

(;-) TP

Trying it with the box ticked, and using the 6 macros I was testing earlier today. Its really slow, but looks like its okay so far. Maybe that was the problem? I think it's now decrementing an axis waiting for a non existant switch to tell it it's hit the end of its travel, so I'd say it pretty much works now.

Just one box unticked, that seems to have been it.

Thanks again all!